/**
* Feed the bytes from the EEPROM file to the editor blocks one after another with an updated bit
* offset. The block objects are responsible for further feeding the bits and bytes to their
* contained editor components.
*
* @param data
*/
private void readFromEepromArray(byte[] eeprom) {
int offset = 0;
// Switch all blocks of so no blocks are displayed that are not used for the device if anything
// goes wrong reading the bytes from the file (e.g. file too short).
for (Block b : blocks) {
b.setVisible(false);
}
for (Block b : blocks) {
boolean match = true;
// If a block has a condition set, check it and override
// using this block if it is not matched.
if (b.restrictionRefID != null) {
String val = findValue(b.restrictionRefID, false);
match = val.equals(b.restrictionValue);
}
b.setVisible(match);
if (match) {
int bitsProcessed = b.readFromEepromArray(eeprom, offset);
offset += bitsProcessed;
}
}
length = offset;
}
/**
* Assume that blocks are restricted by the DeviceType only (as true for smarthomatic) and switch
* the blocks on/off using the given deviceTypeID. This is for use for the Firmware source code
* creation process ONLY!
*
* @param deviceTypeID
*/
public void enableEditorsForDeviceType(int deviceTypeID) {
byte[] dummy = new byte[1024];
int offset = 0;
for (Block b : blocks) {
boolean match = true;
// If a block has a condition set, check it and override
// using this block if it is not matched.
if ((b.restrictionRefID != null) && b.restrictionRefID.equals("DeviceType")) {
match = b.restrictionValue.equals("" + deviceTypeID);
}
b.setVisible(match);
if (match) {
int bitsProcessed = b.readFromEepromArray(dummy, offset);
offset += bitsProcessed;
}
}
}