Exemplo n.º 1
0
  /**
   * Method for retrieving data values from the sensor. BYTE0 ( is usually the primary data value
   * for the sensor. Data is read from registers in the sensor, usually starting at 0x00 and ending
   * around 0x49. Just supply the register to start reading at, and the length of bytes to read (16
   * maximum). NOTE: The NXT supplies UBYTE (unsigned byte) values but Java converts them into
   * signed bytes (probably more practical to return short/int?)
   *
   * @param register e.g. FACTORY_SCALE_DIVISOR, BYTE0, etc....
   * @param length Length of data to read (minimum 1, maximum 16)
   * @return the status
   */
  public int getData(int register, byte[] buf, int length) {
    byte[] txData = {address, (byte) register};
    try {
      nxtCommand.LSWrite(port, txData, (byte) length);
    } catch (IOException ioe) {
      System.out.println(ioe.getMessage());
    }

    byte[] status = null;
    do {
      try {
        status = nxtCommand.LSGetStatus(port);
      } catch (IOException ioe) {
        System.out.println(ioe.getMessage());
        return -1;
      }
    } while (status[0] == ErrorMessages.PENDING_COMMUNICATION_TRANSACTION_IN_PROGRESS
        | status[0] == ErrorMessages.SPECIFIED_CHANNEL_CONNECTION_NOT_CONFIGURED_OR_BUSY);

    try {
      byte[] ret = nxtCommand.LSRead(port);
      if (ret != null) System.arraycopy(ret, 0, buf, 0, ret.length);
    } catch (IOException ioe) {
      System.out.println(ioe.getMessage());
      return -1;
    }
    return status[0];
  }
Exemplo n.º 2
0
 /**
  * Sets a single byte in the I2C sensor.
  *
  * @param register A data register in the I2C sensor. e.g. ACTUAL_ZERO
  * @param value The data value.
  */
 public int sendData(int register, byte value) {
   byte[] txData = {address, (byte) register, value};
   try {
     int ret = nxtCommand.LSWrite(this.port, txData, (byte) 0);
     return ret;
   } catch (IOException ioe) {
     System.out.println(ioe.getMessage());
     return -1;
   }
 }
Exemplo n.º 3
0
 /**
  * Send data top the sensor
  *
  * @param register A data register in the I2C sensor.
  * @param data The byte to send.
  * @param length the number of bytes
  */
 public int sendData(int register, byte[] data, int length) {
   byte[] txData = {address, (byte) register};
   byte[] sendData = new byte[length + 2];
   System.arraycopy(txData, 0, sendData, 0, 2);
   System.arraycopy(data, 0, sendData, 2, length);
   try {
     return nxtCommand.LSWrite(this.port, sendData, (byte) 0);
   } catch (IOException ioe) {
     System.out.println(ioe.getMessage());
     return -1;
   }
 }